Length Selection Guide
| Model | Length | Standoff Class | Best Task Profile |
|---|---|---|---|
| MG002 | 2 ft | Close | High-repetition close-quarters positioning; bench and floor-level components; maximum precision |
| MG004 | 4 ft | Close–Mid | Structural alignment; fabrication yard tasks; routine crane-assisted positioning |
| MG006 | 6 ft | Mid–Extended | Larger assemblies; increased standoff from swing and pinch zones |
| MG008 | 8 ft | Extended | Large module or beam positioning; offshore lifts; high-mass, high-swing loads |
| MG010 | 10 ft | Long | Extended reach where risk assessment demands greater separation |
| MG012 | 12 ft | Maximum | Maximum standoff in the fixed-reach range |
| FG008 | 4–8 ft | Variable | Mixed-task environments; variable standoff requirements across the crew's work |
Fixed vs Telescopic — Side-by-Side
| Characteristic | Fixed-Length (MG002–MG012) | FG008 Telescopic Pole |
|---|---|---|
| Standoff | Fixed — set by model selection | Adjustable 4–8 ft |
| Magnetic head | 75 mm / 550 lb | 60 mm / 275 lb |
| Best for | Consistent standoff, high-repetition, defined tasks | Variable standoff, mixed tasks |
| Weight at length | Lower for equivalent length | Fibreglass keeps weight manageable at full extension |
| Inspection | Standard pre-use check | Standard check plus extension collars and locking mechanism |
Practical Starting Point
Plants running mixed operations commonly standardise on MG004 (4 ft) for daily use, supplemented by MG008 (8 ft) or the FG008 telescopic pole for larger or higher-swing tasks. This two-tool approach covers the majority of industrial positioning requirements without requiring a large tool inventory.
Premium Engineering Consultation
Not sure which configuration fits the task?
PSC's Application Mapping Review examines the actual task — the load, the surface, the access conditions, and the operator's movement — and recommends the correct matched configuration.
Request a Load-It® Application Mapping Review Load-It® System →