Fibreglass Telescopic Magnetic Push Pull Tool | PSC FG008

pschandsfree.com › Load-It® MagHead › FG008 Fibreglass Telescopic Pole

Commercial · PSC Load-It® FG008 Telescopic

FG008 — 4–8 ft Fibreglass Telescopic Load-It® MagHead

One tool. Adjustable working distance. The FG008 fibreglass telescopic pole provides a 4–8 ft working range for crews whose standoff requirement varies across tasks or shifts.

Why Fibreglass

The FG008 uses a fibreglass telescopic pole rather than a metal shaft for two reasons: weight and electrical properties. At full 8 ft extension, handling weight becomes a significant factor in operator control and fatigue across a shift. Fibreglass keeps the pole's handling weight manageable at full extension. Fibreglass is also electrically non-conductive — a relevant secondary consideration in environments where a metal extension pole would be undesirable near live electrical equipment.

The 60 mm · 275 lb Head

The FG008 uses a 60 mm head rated at 275 lb — not the 75 mm, 550 lb head used on fixed-length tools. This is a deliberate engineering decision, not a cost reduction. At the leverage present when the pole is extended toward its full 8 ft reach, a 75 mm, 550 lb head would present more resistance to intentional disengagement than an operator could comfortably manage. The 275 lb rating is deliberately matched to the leverage and handling characteristics of the telescopic pole at extension.

Configuration Options

Available in the same three head configurations as the fixed-reach range: 90° Flex Head, 180° Swivel Head, and 360° Rotation. Head selection follows the same decision logic — the primary question is whether the operator's position changes during the task.

Inspection Requirements

Requires the standard pre-use check for all Load-It® tools, plus additional inspection of the extension mechanism: the extension collars must seat securely and the locking mechanism must engage positively at the required length before each use. A telescopic pole with a locking failure at extension presents a different risk profile from a fixed-length tool — this inspection step must not be omitted.

Who the FG008 Is For

  • Maintenance crews who move between tasks with different standoff requirements
  • Construction sites where lift geometries and access conditions vary
  • Multi-discipline operations with mixed task profiles
  • Smaller crews where reduced tool inventory is a priority

For operations with a narrow, well-defined range of tasks and consistent standoff requirements, a fixed-length tool is typically the better choice — lighter, more rigid, with simpler inspection and more predictable handling.

Premium Engineering Consultation

Not sure which configuration fits the task?

PSC's Application Mapping Review examines the actual task — the load, the surface, the access conditions, and the operator's movement — and recommends the correct matched configuration.

Request a Load-It® Application Mapping Review Load-It® System →